Fishing for Ideas

If you’ve ever worked with preschoolers, I’ll bet you’ve enjoyed magnet fishing. You put a paper clip on the ends of paper fish and a magnet on the end of a homemade, kid-sized fishing pole and then “attract” fish. My grandson likes to put his fish in a bucket and use it as a fishing pond. We’ve been playing this for over a year and it doesn’t seem to get old.

G fishin

Many times, I end up “fishin” too, but it’s usually not in a bucket. It’s usually in my head when I’m fishing for ideas. I may be looking for something new and different to add to a design or for some way to solve a problem. This week it was the latter.

I’ve been stuck on making birds lately and have explored how to do it with embossing and torch enameling.

torch bird

After making a couple of these, I realized that the two don’t mix real well. For embossing, we need a light gauge metal and for torch enamel a heavier metal. When I use the gauge I need for embossing and then enamel the piece, it curves a bit toward the back. Yesterday, while fishing for ideas, I tried riveting another piece of metal to the embossed one and then enameling. It was NOT a good idea. Much of the heat was lost between the layers and I completed a very rough and ugly bird. No, you cannot see it because it’s in the trash. So, I guess I’m going to need to get my idea fishing pole out and try again.

I did, however, have one bird that turned out well. He/she is a sample piece that combines elements from several of the classes I teach, soldering, riveting, wire wrapping, forging, etc. Although you can’t tell from the photo, I used tube rivets to help the bird stand about 1/4 inch away from the back plate. The bird is mixed metal including copper sheet, 1/10 silver wire and brass wire for the nest. Today’s issue is how to make it smaller.

birdie

I asked my spouse if he thought I needed eggs in the bird’s nest, but he didn’t think so. We decided that bird was just too young to mate. After all it did just hatch at Dreamcatcher Designs.

Here’s hoping you catch whatever you are fishing for.

2 thoughts on “Fishing for Ideas”

Comments are closed.