I wonder who it could be. Do you remember reading the August 11 entry describing how the pickle ate my pants? Well, today, the flux helped turn them white. I was happily spending some uninterrupted time with the torch when my bottle of Aquiflux fell off the table and rolled to some far away place. Oh well, I thought, I can just use the new paste flux sitting right here beside me. I hadn’t used much of it previously, but today seemed like a good day to give it a workout. All was well and I completed a ring with a bezel and two butterfly pendants before I noticed my pants. No, there weren’t any new holes in them, but one leg was practically covered in something white and powdery. Flux! Then I noticed that my hands had a good deal of dry flakes on them. Flux! The paste flux actually worked fine for my projects, but I’m not sure that I like the extra mess. I tried to take a bit more care with it on the rest of my projects, but when I went upstairs to clean up, I noticed I also had white spots on my nose and cheeks. Now you tell me how in the world I managed to get flux on my face. I guess you can just call me the messy metal smith.

By the way, I’m dangerous too. Last week, I managed to reach across the extinguished torch before it cooled. My arm came in contact with the torch and I have quite a nasty burn on my inside arm. It was becoming infected until I started flooding it with hydrogen peroxide. It appears that I’ll live to torch another day. Scars are good . . . right?

In spite of all the mess and the bandaged arm, this was a fairly productive day. As you can see from the photos below, I ended up with two sterling silver rings, two butterflies and two star earrings.

I cut the shapes on the butterfly wings with my disc cutter and then sweat soldered them onto the copper shapes. The center piece on the right flutter by is made from a beaded wire.

 

The sterling silver ring sports a lapis stone that I put in a premade bezel cup. It has a little sterling silver flower sweat soldered on the side.

I used some very thin copper sheet for the star part of the earrings (or pendants) below. I’m trying out a paper cutter that cuts a star to see how long it will last with this type abuse. It does a fine job of cutting and I’ll just wait and see regarding its life. I appreciate the friend who shared this technique with me. I’ll let you know if it appears to be worth the relatively small investment in decorative paper punches.

        

The last ring shown is from the new Kim St. Jean book mentioned in another entry.

I hope you aren’t as messy as I am, but I DO hope you’re having as much fun as I am! Does that make it OK to be a messy metal smith?